20% OFF - All Manual Fastener Installation Machines

This exceptionally versatile tool is ideally suited to all levels of production: from a single unit for prototype assembly, to multiple units on an assembly line.  The Model PM Manual Pin Inserter easily accommodates quick change-overs.  The part holding device (fixture) is simply replaced from the base of the machine.  The pin diameter is easily changed, positive pin depth easily adjusted, and part size variation easily accommodated.  The use of high-tech shafting and bearings results in smooth operation, precise positioning, repeatability, and durability.

The Model PM Manual Pin Inserter installs pins ranging in diameter from 0.8mm-4mm (.031”-.156”) with a maximum insertion force of 0.9 kN (200 lbs).

The precisely machined rack and casting results in smooth operation, precise positioning, repeatability, and durability.

The Model PMH Heavy Duty Manual Pin Inserter installs pins ranging in diameter from 0.8mm-10mm (.031”-.375”) with a maximum insertion force of 6.7 kN (1,500 lbs).

This versatile tool is ideally suited for low to moderate levels of production for assemblies that require installation forces up to 22.2 kN (5,000 lbs). The Model PMX Extra Heavy Manual Pin Inserter easily accommodates quick change-overs. The fixture is simply replaced at the base of the machine, and the pin diameter is easily changed by switching the pin driving chuck. This Extra Heavy Duty Manual Pin Inserter will provide smooth operation, repeatability and durability.

Designed to install virtually any type of Heat / Ultrasonic Style Insert. As much as 75% of an Insert’s performance is the direct result of how well it was installed.  Therefore, in order to maximize performance, all of the factors that impact installation must be carefully controlled.  SPIROL’s Model HM Manual Insert Driver has been designed to eliminate the dependency on the operator to control these factors.  The result is nearly perfect flow of the plastic for optimal retention and performance.

The Model HM Manual Insert Driver is simple to operate and easily adjustable.  The Model HM installs Inserts ranging in size from M2 - M6 metric threads and #2 - 1/4 unified threads, and the simple up-down adjustment of the machine makes it easy to accommodate various sized plastic components.

This exceptionally versatile tool for post-mold assemblies is ideally suited to all levels of production: from a single unit for prototype assembly, to multiple units on an assembly line. The SPIROL^® Model CM Manual Compression Limiter Installation Machine easily accommodates quick change-overs by simply:

1. Replacing the fixture
2. Swapping insertion punch/pusher tip
3. Adjusting the positive stop for new install height.

The use of high quality shafting and bearings results in smooth operation, precise positioning, repeatability, and durability.The Model CM Manual Compression Limiter Installation Machine installs Compression Limiters ranging in diameter from M3 to M10 metric and #4 to 3/8" unified, and has a maximum insertion force of 0.9kN (200 lbs).